Stream a live test from the DLRO2X low resistance ohmmeter [09-0000]

• Tap the red 'Connect BT' button (top right of the screen)
• CertSuite looks for the available Bluetooth devices
• Serial numbers of the available devices are listed in the 'Instrument Data' panel
• Tap the blue button that displays the serial number matching your device
• Once there is a successful connection the red 'Connect BT' button in CertSuite Asset turns green
• The button also displays the serial number of the connected device

• The 'Add New Test' screen appears
• Tap the 'Instrument Data' button, and at the next screen tap the 'Bluetooth' button - this takes you to the 'Test details' screen in CertSuite
• On the tester - press the hot key (left hand key) to toggle between single test measurement, and continuous measurement: to stream, this key must be set to continuous measurement
• Before starting the test, press and hold the 'Save' key for 3 seconds
• This puts the tester into 'streaming mode'
• Press the red 'TEST' button to begin the streaming
• The test data is transmitted to CertSuite - where the results can be viewed as graphs, and as tables
• Press the 'TEST' button again to end the test
• At the next screen, tap 'OK' to add the test to the stored data on the device, and 'Cancel' to end the session without saving the data
• Regardless of whether the data is stored on the tester, the test results can now be viewed, saved, and printed, in CertSuite

[Article 09-0000-00]